A test tone is output from a different speaker than the speaker displayed on the display panel. No image and/or sound is output from the TV when the receiver is in the standby mode. Image. No image appears on the TV screen. No 4K content appears on the TV screen. No image and/or sound is output from the TV when the receiver is in the standby mode. How to connect a computer to an A/V receiver. The type of audio connection between the A/V receiver and the computer will vary based on the available input and output connections that are available on the A/V receiver and the computers sound card. When making an analog connection, a stereo mini pin to A/V connection adapter will be needed. Connect the speaker wires to your speaker: Start by connecting the wires to your speaker by locating the terminals at the back of your speaker. Make sure that the wires are correctly connected to the positive and negative terminals. Connect the speaker wires to the amplifier: The next step is to connect the wires to the amplifier or receiver. Step 4: Connect the Speaker Wire to the Receiver. Now it’s time to connect the speaker wire to the receiver. Locate the speaker outputs on the back of your receiver. There will typically be a red and a black output for each channel. Connect the positive (+) end of one of your speaker wires to the red output for the channel you want to connect 986 posts · Joined 2009. #4 · Jun 11, 2010. 4 wire is often used to run stereo pairs in homes. 2 wires (red, black) handle one channel and 2 wires (green, white) handle the other channel. What I used to do was run the 4 conductor to one speaker, split the jacket pull out the 4 conductors, cut the green/white if it was the left channel speaker Step 1. Find the external antennae connection on the rear of the receiver. It may be labeled "ext. ant" or "ant." Advertisement. Step 2. Wrap each of the two speaker cable wires around the posts at the external antennae connection. If the connection is a clamp-and-hold device then clamp and hold. Step 3. Twist the two wires together into a Unlike the relatively complex nature of audio and video cables, the cables you use to connect speakers are simple. For each speaker, you connect one cable which has two connections: a black wire and a red wire. The black wire is the ground or negative wire and the red wire is the positive wire, but you don't even need to know that. Pick the speaker type you want to use: soundbar, stereo or surround sound speakers. Find the audio output on your TV. Find the matching audio input on your soundbar or amplifier. Wire the TV’s audio output to the input of your soundbar or amplifier (and wire the speakers to the amplifier if you’re not using a soundbar). The BRAVIA Acoustic Center Sync or S-Center speaker input on the TV allows you to connect with a compatible Sony soundbar/audio system to the TV for enhanced audio playback using the TV as a center channel speaker in a multi-channel setup. Note: The S-Center speaker input is compatible with the HT-A9 and HT-A7000 soundbar models. 35eT.

how to connect speaker wire to sony receiver