But after turning the phantom back on the controller no longer communicates with the camera. Green light is on the RC, but it either says disconnected or weak transmission. A red light flashes on the gimbal after it is turned on. I can not get it solid green anymore. When trying to install the original firmware 1.11 that installs as well. The status of PIX4Dcapture support for the different drones, cameras, and controllers is described in the table below. When the app has not been tested, it means that the app could work, but Pix4D makes no guarantee. If a non-DJI camera is mounted on DJI drones, PIX4Dcapture will not be able to trigger the camera. 4#. It's the firmware upgrade that destroys circuits on the board, DJI know about this problem and have decided to turn a blind eye. Everything else on the control panel will work, the camera included, just no live feed. (See Photo). You will need to send the drone away for repair. 2019-3-10. Hello. After not using my DJI Phantom 3 Professional during winter I have updated firmware to latest (v. 1.8.80) on both devices - RC, aircraft. DJI Pilot version for Android is also the latest - 2.8.1. And now entering to camera view I see only black screen. But camera is recording the pictures and video - problem is only that I don't see it on my phone. How I tried to solve: - rebooting RC After getting the drone put back together I boot it up and the camera stays stationary/limp. There is video feed and everything else seems to work fine, but the camera motors dont move it at all, in any direction. I can hear a slight buzzing sound from the motor that keeps the camera horizontal, if I move it then the buzzing gets a little louder. To make things a bit more secure, we changed the WIFI SSID and the WIFI password via the DJI Go application (for clarity purposes: DJI Go > Selected PHANTOM 3 STANDARD > Camera > clicked on the wifi icon > changed the default SSID and WIFI. 4. We powered the Android Phone + Remote Control + Drone off and back on. 5. 1#. I just upgraded firmware and upgraded remote. I ploaded DJI Go for my iphone 6s. I select my PH3A in the app "Connect your DJI device". The only thing on the screen is "How to Connect". I don't get camera view. I deleted the app an reinstalled it because it wasn't connecting. Now I got nothing. USB cord is plugged into remote and iphone My camera is not transmitting to my android phone or iPad. Says connection lost. I have replaced the WiFi module and have preformed binding to the range extender. Still the same message. When I replaced the module, I found the module in the bird had a dent in it, from a bad crash. However, the camera worked on a flight last fall after the crash. The Phantom 3 runs with the older version flight control app, so you should download the DJI Go app for your Phantom 3. If you’re flying a Phantom 4, you should download the DJI Go 4 app. The two apps are basically the same, but with a few upgrades to the latter. Both apps are available on Android and iOS. Phantom 3. Download DJI Go App for Zg09rVX.

dji phantom camera not working